BLOGGER TEMPLATES AND TWITTER BACKGROUNDS

Tuesday, August 17, 2010

Tuesday Tutorial -- brenna’s paper capiz shell chandelier

This is in the catagory of "Oh my God!"  This is just too beautiful to believe.  I hope someone has a place they can hang such a beautiful chandelier and they make this because I am dying to know if it turns out just as beautiful as this picture.  Maybe when I move to a new house, I will get to try this.  I certainly hope so.

This is from Design Sponge and there are many other wonderful DIY items also.
____________________________________________________________________________________

i love wax paper for packing lunches; i wrap sandwiches in a piece of wax paper and tie it like a present with a little cotton string. it’s so much better looking than a
plastic bag. wax paper comes in handy for more things than i realized, like rolling it up to use for a funnel, or how about rubbing a piece of wax paper on the top of your
shower curtain rod to cut down on that terrible screeching in the morning…problem solved. but who knew that if you iron layers of wax paper together it looks remarkably similar to a capiz shell? this discovery brought me to today’s project: the faux capiz chandelier. hung over your dining table, or outside at an outdoor dinner party, it is an easy solution to a dramatic light fixture and will look phenomenal in either setting. i hope you enjoy making your own as much i did! -brenna



Materials:
- hanging planter basket
- white spray paint
- ribbon
- scissors
- 1-2 rolls wax paper
- 2 big pieces of parchment paper
-  iron
- hot glue gun & glue sticks
- circle cutter (i didn’t have any luck with a “punch”)
- cutting mat
Instructions:
1.  spray paint your planter basket. let dry.

2.  start making the capiz shells. lay out the two pieces of parchment paper on your ironing board or on a clean dish towel on the floor or table. (if you use your floor or
table, just make sure it wont be damaged by the heat of the iron)
3.  cut three pieces of wax paper about the same length. mine were about 18”. sandwich the three pieces of wax paper between the parchment paper. the parchment paper allows the wax to stay within the layers of paper, helps it stick together, and gives the wax paper a smooth finished surface.
4.  iron the paper sandwich on a low setting. remove the layered wax paper from between the parchment, and repeat.
5.  set the circle cutter to cut 2 ½ inch circles. with the circle cutter, cut circles from the layered wax paper on your cutting mat. it helps to tape the wax paper down to
the mat.

6.  cut ribbon pieces and attach the ribbon to the planter basket. the length of the ribbon will depend on the method of attachment to the basket… (single or double strand). my lengths were between 7 (single) and 16 inches (doubled). you can attach them to the basket either by hot gluing the end of a single strand to the basket wire, or by folding the ribbon in half, and creating a knot over the wire. start at the bottom, and work your way up.

7.  once you finish one tier of ribbon, attach the capiz shells to the ribbon with a tiny dot of hot glue near the top of each shell. i alternated two and three shells on each ribbon and only attached shells to every other ribbon. overlap the shells by about ¼”. finish an entire lower tier, then move on to the next higher tier.

8.  once you cover the hanging basket you are done! you can attach a simple bulb of you want this to be a source of light. hang in your desired location, stand back and
admire.








CLICK HERE for the full how-to after the jump!


Materials:
- hanging planter basket
- white spray paint
- ribbon
- scissors
- 1-2 rolls wax paper
- 2 big pieces of parchment paper
-  iron
- hot glue gun & glue sticks
- circle cutter (i didn’t have any luck with a “punch”)
- cutting mat
Instructions:
1.  spray paint your planter basket. let dry.

2.  start making the capiz shells. lay out the two pieces of parchment paper on your ironing board or on a clean dish towel on the floor or table. (if you use your floor or
table, just make sure it wont be damaged by the heat of the iron)
3.  cut three pieces of wax paper about the same length. mine were about 18”. sandwich the three pieces of wax paper between the parchment paper. the parchment paper allows the wax to stay within the layers of paper, helps it stick together, and gives the wax paper a smooth finished surface.
4.  iron the paper sandwich on a low setting. remove the layered wax paper from between the parchment, and repeat.
5.  set the circle cutter to cut 2 ½ inch circles. with the circle cutter, cut circles from the layered wax paper on your cutting mat. it helps to tape the wax paper down to
the mat.

6.  cut ribbon pieces and attach the ribbon to the planter basket. the length of the ribbon will depend on the method of attachment to the basket… (single or double strand). my lengths were between 7 (single) and 16 inches (doubled). you can attach them to the basket either by hot gluing the end of a single strand to the basket wire, or by folding the ribbon in half, and creating a knot over the wire. start at the bottom, and work your way up.

7.  once you finish one tier of ribbon, attach the capiz shells to the ribbon with a tiny dot of hot glue near the top of each shell. i alternated two and three shells on each ribbon and only attached shells to every other ribbon. overlap the shells by about ¼”. finish an entire lower tier, then move on to the next higher tier.

8.  once you cover the hanging basket you are done! you can attach a simple bulb of you want this to be a source of light. hang in your desired location, stand back and
admire.

Blog Widget by LinkWithin
Enhanced by Zemanta

0 comments: